| 钢纤维混凝土井盖制造工序 |
| 添加时间：2019/2/16 14:59:11 浏览次数： |
| 钢纤维混凝土井盖制造工序 Manufacturing Procedure of Steel Fiber Reinforced Concrete Well Cover 用以代替铸铁雨水口箅子及井盖，可以减轻构件重量近30%，降低造价50%左右，可满 足汽?5重车荷载使用要求，并有效地解决了丢失问题。其外形尺寸为：箅子(长×宽×厚) 750×450×35mm，井盖Φ750mm和Φ650mm两种。该产品具有完整的设计及配筋图纸，成熟 的生产工艺，定型的及定点的模工单位和相应的模具加工图纸，有先进和设备选型，可代为 加工和购置配套设备。箅子可与S235建设部通用图的箅子框通用，井盖原则上按国际S147的 有关尺寸确定，井盖应与本设计匹配的井圈配套使用 It can reduce the weight of components by nearly 30% and the cost by about 50%. It can satisfy the requirement of steam? 5 heavy truck load and effectively solve the problem of loss. Its shape and size are as follows: the size of mud (length * width * thickness) is 750 * 450 * 35 mm, and the cap is 750 mm and 650 mm. The product has complete design and reinforcement drawings, mature production technology, fixed-point and fixed-point die units and corresponding die processing drawings. It has advanced and equipment selection, and can be used for processing and purchasing supporting equipment. The seal can be used in common with the seal frame of the general drawing of S235 Ministry of Construction. In principle, the well cover is determined according to the relevant dimensions of international S147. The well cover should be matched with the well ring matched with this design. |
| 上一页 钢纤维混凝土井盖的作用 |
| 下一页 隐形井盖的设计及注意事项 |
Copyright © 技术支持：遨游网络